How to apply your Bold padel overgrip in 5 easy steps?

Step 1. Remove the old overgrip (if any)

Before applying your Bold overgrip, make sure to take off any old overgrip on your racket handle.
Start at the top and peel it off completely until you reach the base grip (the grip that came with the racket).
A clean handle ensures the new overgrip sticks properly and performs at its best.

Step 2. Unroll your Bold overgrip

Take your new Bold overgrip out of the packaging.
Remove the thin protective plastic film from the outside.
Peel off the small adhesive sticker from the narrow, sloped end — this is the starting point of the grip.

Make sure you have the included finishing tape nearby for the final step.

Step 3. Start at the base of the handle with the sloped side facing down

Begin by sticking the adhesive end of the overgrip to the bottom of the handle, right above the butt cap.

Make sure the sloped side of the grip is facing downwards — this creates a neat starting point and is especially important for designs like country flags, where alignment matters for the visual effect.

Step 4. Wrap upward with consistent overlap

Wrap the overgrip tightly around the handle in a smooth, upward spiral.
Each wrap should overlap the previous layer by about 6 mm — this provides optimal grip and comfort.

Keep the tension consistent and make sure the grip stays smooth as you go. Wrinkles or uneven gaps can affect both feel and performance.

Step 5. Trim and finish your grip

Once you’ve reached the top of the handle, trim off any excess overgrip with scissors — ideally at an angle to match the slope of your final wrap.

Then, use the finishing tape included in the pack to secure the end of the grip firmly in place. Press it down to ensure everything stays in position.